— PRODUCT INTRODUCTION

Tee is also known as tee pipe fittings or tee pipe fittings, tee joints, etc.Mainly used to change the direction of the fluid, used in the main pipe to branch pipe.It can be classified according to pipe diameter.It is generally made of carbon steel, cast steel, alloy steel, stainless steel, copper, aluminum alloy, plastic, argon mold, PVC and other materials.

According to pipe diameter and size:

The nozzle ends of equal diameter tees are all of the same size;

The pipe nozzle size of the reducing tee is the same, while the pipe nozzle size of the branch pipe is smaller than the pipe size of the pipe.

By material:

Carbon steel, cast steel, alloy steel, stainless steel, copper, aluminum alloy, plastic, argon mold, PVC, etc.

Divided by production method:

Top, pressing, forging, casting, etc.

HYDRAULIC BULGING:

The hydraulic bulging of the tee is a forming process by which the axial expansion of the metal material compensates the expansion of the branch pipe.The process is to use special hydraulic press, with three links within the tube billet diameter equal injection liquid, through the two horizontal side of the hydraulic cylinder synchronization of the motion of tube billet, billet after squeezed smaller volume, smaller volume of liquid with the tube billet inside the tube billet and pressure, when pressure tee branch pipe bulge out to the metal material in the liquid in the cylinder and the pipe pressure under the dual role of flow along the mold cavity and the branch pipe.

Three - way hydraulic bulging process can be formed once, high production efficiency;The head of the tee and the wall thickness of the shoulder increased.

Due to the large tonnage of equipment required by seamless hydraulic bulging process, it is mainly used for the manufacture of standard wall thickness tee less than DN400 in China.The suitable forming materials are low carbon steel, low alloy steel and stainless steel with relatively low hardening tendency, including some non-ferrous metal materials, such as copper, aluminum and titanium.

THERMOFORMING:

Three-way hot pressing is to flatten the tube billet larger than the diameter of the three-way to the size of the diameter of the three-way.

COLD DRAWING TEE:

Make a hole in the part of the drawing branch;The tube billet is heated, put into the forming die, and the punching die of the stretch branch tube is put into the tube billet.Under the action of pressure, the tube billet is compressed radially. In the process of radial compression, the metal flows to the direction of the branch tube and forms the branch tube under the extension of the punching die.The whole process is formed by the radial compression of the tube billet and the drawing of the branch tube.Different from the hydraulic bulging tee, the metal of the hot-pressed tee branch pipe is compensated by the radial movement of the tube billet, so it is also known as the radial compensation process.

Due to the use of heating pressing tee, the material forming equipment tonnage is reduced.It is suitable for the materials of low carbon steel, alloy steel and stainless steel.In particular, large diameter and wall thickness of the tee, usually adopted this forming process.

— PRODUCT DISPLAY

— PRODUCT COMPOSITION

— PRODUCT DETECTION

— PACKAGE DELIVERY

20ft GP:5898mm(Length)x2352mm(Width)x2393mm(High) 

40ft GP:12032mm(Length)x2352mm(Width)x2393mm(High)  

40ft HC:12032mm(Length)x2352mm(Width)x2698mm(High)

Standard export packing wooden pallet, wooden case, etc. (inside: waterproof paper, outside: steel belt and pallet)